ds2000-3 2000 watts 12 v distributed power system distributed power bulk front-end total output power: 2000 watts +12 vdc main output +3.3 or +5.0 vdc standby output wide range input voltage: 90 - 264 vac special features ? active power factor correction ? en61000-3-2 harmonic compliance ? active ac inrush control ? 1u x 3u form factor ? 26.14 w / in 3 ? +12 vdc output ? +3.3 vdc or 5.0 v standby ? no minimum load required ? hot plug operation ? n + 1 redundant ? internal oring fets ? active current sharing (10 - 100% load) ? built-in cooling fans (40 mm x 28 mm) ? i 2 c communication interface bus ? pmbus compliant ? eeprom for fru data ? green and amber led status ? internal fan speed control ? intel, ssi std. logic timing ? intel, ssi std. fru data format ? two year warranty safety ? ul/cul 60950 (ul recognized) ? nemko+ cb report en60950 ? en60950 ? ce mark ? china ccc electrical specifcations input input voltage range 90 - 264 vac (wide range) 90 - 264 1200 w load, nominal 100 vac 180 - 264 2000 w load, nominal 200 vac frequency 47 - 63 hz, single phase ac inrush current 40 a maximum inrush current effciency > 89% typical at full load, high line conducted emi fcc subpart j en55022 class b radiated emi fcc subpart j en55022 class b power factor 0.99 typical leakage current 1.40 ma @ 240 vac hold-up time 10 ms minimum output main dc voltage +12 v @ 164.2 a 180 - 264 vac +12 v @ 100 a 90 - 264 vac standby +3.3 vsb @ 9 a or 5 v @ 6 a adjustment range factory set, no pot adjustments regulation +12 vdc; 5% +3.3 vsb/+5.0v; 5% overcurrent +12 vdc; latches off if overcurrent lasts over 1 second, otherwise it is auto recovery (see ordering info next page) overvoltage +12 vdc; 13.2 - 14.4 vdc +3.3 vsb: 3.76 - 4.30 vdc, +5.0vsb: 5.5 - 6.25vdc undervoltage +12 vdc; 9 - 10.8 v (latch off) turn-on delay 2 second max +12 v output rise time 5 - 300 ms, monotonic rise data sheet power
ordering information model number nominal output voltage set point set point tolerance total regulation minimum current maximum current output ripple p/p overcurrent airflow ds2000-3 12.2 vdc 3.3 vsb 0.2% 1% 5% 5% 0 a 0 a 161.5 a 9.0 a 120 mv 60 mv 120 - 130% of nominal 100 - 125% of nominal standard DS2000-3-001 12.2 vdc 3.3 vsb 0.2% 1% 5% 5% 0 a 0 a 161.5 a** 9.0 a 120 mv 60 mv 120 - 130% of nominal 100 - 125% of nominal reverse ds2000-3-002 12.2 vdc 5.0 vsb 0.2% 1% 5% 5% 0 a 0 a 161.5 a 6.0 a 120 mv 60 mv 120 - 130% of nominal 120 - 140% of nominal standard * overcurrent latches off if overcurrent lasts over 1 second, otherwise it is auto recovery. ** derates per below curve (-001) reverse air environmental specifcations operating temperature -10 c to 50 c storage temperature -40 c to +85 c altitude, operating 10,000 ft electromagnetic susceptibility / input transients en61000-3-2, -3-3 en61000-4-2, 4.3, 4-4, -4-5, 4-11 level en55024:1998 rohs & lead free compliant (no tantalum caps) humidity 20 to 90% rh, non-condensing shock and vibration standard operating and non-operaitng random shock and vibration mtbf (demonstrated) 300 k hrs at full load, 40 c logic control present# ttl logic low if power supply is seated into system connector. this is a short pin. a logic high if the psu is removed. pwok# active ttl low when output is within regulation limits. ac ok# a low logic level if the input voltage is within allowable limits. a ttl logic high level, and a 2 ms early warning signal before 12.0 v dc output loss of regulation. ds200 0-3-00 1 derating curve 0 50 0 1000 1500 2000 2500 -1 0- 50 51 01 52 02 53 03 54 04 55 0 operatin g temperature (c) outp ut p ower (w) low line (90 vac) high line (180 vac) ds2000-3 data sheet
mechanical drawing power supply condition power led (green) fail led (amber) no ac power to psu off off ac present/standby output on blinking off power supply main output on and ok on off power supply main output failure (overvoltage and overtemperature) off on over-current on blinking 295.7 1 (3x) 261. 7 programming hole s 292.1 1 220. 1 325. 2 40370111360 handle 40 0. 8 emi ga sk et lair d te chnologies (s ea ) pt e s3700-0021-00 emi ga sk et lair d te chnologies (s ea ) pt e s3700-0021-00 (3x) emi ga sk et lair d te chnologies (s ea ) pt e s3700-0021-00 la tc h airfl ow dire ct io n 8 3. 2 106.7 0. 8 13.7 0. 8 99.1 0. 8 output co nne ct or mole x 45985-1462 16.3 0. 8 220. 1 325. 2 100. 2 72.2 green wa ve length: 565 yell ow wa ve length: 590 ac inle t labe l orient at io n th is si de up 32 22 ds2000-3 data sheet
ds2000-3 30jul2015 dc output connector pinout/functions unit connector; molex blade, (lph series) 45985-xxx mating connector; molex blade, (lph series) sd-45984-1462 or any approved equivalent signal descriptions signal pin #comp side top row signal function signal description signal pin #solder side bottom row signal function signal description a17 3.3 v sense rtn 3.3 v sen rtn a1 spare a18 ac ok# ac input present a2 spare +stand-by rmt sen a19 a0 i 2 c address bit 0 a3 #alert fail signal a20 a2 i 2 c address bit 2 a4 a1 i 2 c address bit 1 a21 scl* i 2 c clock signal a5 sda i 2 c data signal a22 pwok# pwr ok output a6 present# power supply present a23 12 ls 12 v load share bus a7 pson# power enable input a24 +12 vrs rtn +12 v rmt sen rtn a8 +12 v rs +12 v remote sense a25 3.3 vsb stand-by a9 3.3 vsb stand-by a26 3.3 vsb stand-by a10 3.3 vsb stand-by a27 3.3 vsb stand-by a11 3.3 vsb stand-by a28 3.3 vsb stand-by a12 3.3 vsb stand-by a29 3.3 vsb rtn stand-by return a13 3.3 vsb rtn stand-by return a30 3.3 vsb rtn stand-by return a14 3.3 vsb rtn stand-by return a31 3.3 vsb rtn stand-by return a15 3.3 vsb rtn stand-by return a32 3.3 vsb rtn stand-by return a16 3.3 vsb rtn stand-by return power blade power blade pb1 top +12 vdc main output pb1 bottom +12 vdc main output pb2 top +12 vdc main output pb2 bottom +12 vdc main output pb3 top +12 vdc main output pb3 bottom +12 vdc rtn main output pb4 top +12 vdc rtn main output pb4 bottom +12 vdc rtn main output pb5 top +12 vdc rtn main output pb5 bottom +12 vdc rtn main output * supports i 2 c standard mode (100 khz) only no of si gnals optional see chart to p ro w bo tt om ro w a1 a17 pb1 pb2 pb3 pb4 pb5 t op ro w bo tt om ro w optional pe optional guides mating connector - molex p/ n: 45984-1462 signal pin a1 bottom left signal pin a17 top left ds2000-3 data sheet for more information: www.artesyn.com/power for support: productsupport.ep@artesyn.com www.artesyn.com worldwide offices americas 2900 s.diablo way tempe, az 85282 usa +1 888 412 7832 europe (uk) waterfront business park merry hill, dudley west midlands, dy5 1lx united kingdom +44 (0) 1384 842 211 asia (hk) 14/f, lu plaza 2 wing yip street kwun tong, kowloon hong kong +852 2176 3333 while every precaution has been taken to ensure accuracy and completeness in this literature, artesyn embedded technologies assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. artesyn embedded technologies, artesyn and the artesyn embedded technologies logo are trademarks and service marks of artesyn embedded technologies, inc. all other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. ? 2015 artesyn embedded technologies, inc.
|
